PL-AT-TW1

Features- Compatible with PoE switches and injectors - see table
- Up to 25 watts of LED light in 802.3at mode, 35 watts in passive mode
- Mechanical switch or TCP/IP control
- Data is not used - only power
- Controlled by WiFi - see the Wiz setup information
- Tunable White output - can drive two strings of LEDs to support warm and cool light
- use a $2 rocker switch for On/Off or a RH-253 momentary switch for manual dimming and local override
- connect two in series for 50 watts of light
Dimming Control Methods
- Uses the Philips Wiz OEM module to offer on/off/dimming via
- Mechanical Switch control
- use a simple wall switch for On/Off operation
- use a RH-253 momentary switch for On/Off/Dimming
- Recommended single color LEDs to drive:
802.3af, 802.3at, PoE+, Passive
Mode
| Max Power
| Current default
| Default Max Vf
| Current Option
| Option Max Vf
| Sample LED
|
802.3af
| 13 watts
| 300 mA
| 40 Volts
| 300 mA
| 40 volts
| P023R6 two in series
|
802.3at
| 25 watts
| 700 mA
| 34 Volts
| 1000 mA
| 25 Volts
| P023R6 four in series |
Passive
| 35 watts
| 700 mA
| 45 Volts
| 1000 mA
| 35 Volts
| P023R6 five in series |
- Recommended tunable white LEDs
- Sharing one PoE port for 2x 25 watts on one Ethernet cable
50 watts of LEDs in 2 fixtures is possible with two PL-AT-TW1 in series
diagram for two PL-AT-TW1 on a single 802.3bt port - 50 watts
Set the Passive jumper to enable 700 mA or 1000 mA operation with a passive injector
Set the 1000 mA jumper to boost current from 700 mA in 802.3at or passive mode