AL-Z25-PIR
Use this device to power a BS010WL PIR sensor and up to two LEDs type P023R6-660mA
- purchase the BS010WL here on Amazon $11
- connect the power from the DR2 LED driver to the female 2.1mm input connector ( cut and use lever nuts if possible)
- connect the output to the LEDs in series ( 2.1mm male connector - cut and use lever nuts)
- adjust the sensor as needed
the output voltage will be limited to 24 volts so that the BS010WL is not damaged. The LEDs can be dimmed from the DR2 as usual.
Uploading ....